- rg560
-
Custom Total utilisateur
salut;
j'ai lu que l'on pouvait rêgler un selecteur d'impedance plus haut que l'impédance du hp.
mettre le selecteur sur 16 ohm au lieu de 8 ohm pour un hp en 8 ohm.
quelle risque pour l'ampli et surtotu ça change quoi au niveau du son???
"Output Impedance. The standard JTM reissue output transformer has a primary of about 6.5k, which is about 65% higher than your typical two-tube Marshall iron in an EL34 amp (e.g. 50w plexi). If you want more of an aggressive sound, set the selector one notch higher than the load, i.e. set it at 16-ohms for an 8-ohm cabinet, which tends to make the tone much more Marshally. It has been said that using the impedance selector in this manner will make the amp louder and it will sound less "constricted"
source:http://www.raw-sewage.net/jtm45ri_mods.html
j'ai lu que l'on pouvait rêgler un selecteur d'impedance plus haut que l'impédance du hp.
mettre le selecteur sur 16 ohm au lieu de 8 ohm pour un hp en 8 ohm.
quelle risque pour l'ampli et surtotu ça change quoi au niveau du son???
"Output Impedance. The standard JTM reissue output transformer has a primary of about 6.5k, which is about 65% higher than your typical two-tube Marshall iron in an EL34 amp (e.g. 50w plexi). If you want more of an aggressive sound, set the selector one notch higher than the load, i.e. set it at 16-ohms for an 8-ohm cabinet, which tends to make the tone much more Marshally. It has been said that using the impedance selector in this manner will make the amp louder and it will sound less "constricted"
source:http://www.raw-sewage.net/jtm45ri_mods.html
