Firmware 7.07 disponible pour le standard ici :
http://www.fractalaudio.com/Do(...)7.zip
Au menu :
7.07
Fixed Synth block frequency being overwritten by 2nd Synth block.
Fixed Delay block LFO depth not being updated on tempo change.
Fixed Drive block mix control affecting balance.
Replaced “4x12 V30” cab with new IR. Sounds similar to pre-7.05.
Replaced “4x12 30W” cab with new Mesa IR.
Reprocecessed the following IR’s for better sound quality:
2x12 Boutique
4x10 Bass
4x12 75W
4x12 T75
Set “MR Z 38 SR” bias to default to 0.75 (as it should, previously defaulted to 0.35).
Increased amount of drive available in Cab block. Any presets using the Drive parameter will need to be auditioned.
Improved speaker distortion modeling in Cab block. New algorithm models change in impedance as voice coil leaves air gap.
Improved Pedal type in Compressor block. Improved detector algorithm. Also, independent control over attack and release rates is now provided. Existing presets will need to be auditioned.
Added several functions to support new editor software and upcoming MFC-101 MIDI Controller.
*******************************************************************************
7.06
Fixed Master knob in Amp block not moving if modifier attached.
*******************************************************************************
7.05
Fixed garbage in Compressor input detector if selecting a null sidechain source.
Improved variable delay algorithm (chorus, flanger, etc.). Sidelobe clutter now reduced to immeasureable levels.
Improved interpolation filters (again) by fine-tuning window.
Removed “4x12 V30” IR and replaced with Marshall V30 IR.
Removed “4x12 Recto2” IR and replaced with new Oversize Mesa IR.
***********************************************************************